When you select an industrial controller, the processor is only part of the decision. Network access, field I/O, serviceability, power and software requirements often drive the final architecture. The NORVI X platform uses modular expansion hardware, so the first choice is whether the CPU needs cellular connectivity.
The common foundation
Both X1 and X3 use an ESP32-S3 controller platform with Wi-Fi, Bluetooth, wired Ethernet, RS-485 communication and an integrated display. Both are intended for modular NORVI X expansion. That means a controller can begin with a few channels and grow as the machine or monitoring site changes, within the platform’s electrical and bus limits.
Choose X1 for an existing network
If your control cabinet already has reliable Ethernet or an approved industrial Wi-Fi network, X1 may be the most straightforward choice. Local connectivity can keep ongoing network costs down and avoid a separate cellular contract. Use the NORVI X1 industrial controller for machines, panels and installations where network access is already planned.
Choose X3 for sites that need 4G LTE
X3 adds a Quectel EC25 LTE modem to the NORVI X architecture. That makes it relevant for remote assets, temporary installations or environments in which a hardwired network is impractical. But a cellular modem does not guarantee service: carrier band support, regional certification, SIM plans, antenna placement and local signal conditions still need to be validated.
Review the NORVI X3 LTE controller when the use case requires wide-area connectivity in addition to local wired options.
Decide on I/O before ordering the CPU
- Digital inputs: sensor state, switches, pulses and contact status.
- Relay and transistor outputs: the right option depends on load voltage, current, switching frequency and circuit protection.
- Analog inputs: match the actual transmitter signal range—such as 4–20 mA or 0–10 V.
- Temperature: RTD, NTC and thermocouple interfaces are not interchangeable.
Also check shared I²C addresses and direct GPIO conflicts between expansion modules. The X-DI4 and X-UARTIO require particular attention because they can contend for the same GPIO resources.
Selection checklist
- Confirm whether the site has Ethernet or industrial Wi-Fi.
- For LTE, verify the actual carrier and cellular module bands before purchase.
- Count digital, analog and serial I/O, and identify each sensor voltage/current type.
- Check supply voltage, enclosure environment and appropriate protections.
- Decide how the software will communicate with the destination controller or cloud.
If you are comparing multiple configurations, contact NORVI USA with your I/O schedule and connection requirements. We can help identify which CPU and module combination deserves closer engineering review.