Industrial IoT Controllers & Remote Monitoring · U.S. Distributor

Ordering a modular controller starts with more than a CPU. You need a repeatable bill of materials (BOM) that matches real signals, power and network access. This guide illustrates how to organize the first NORVI X configuration while leaving space for engineering validation.

1. Pick the CPU based on connectivity

Choose NORVI X1 when the machine will use wired Ethernet or local Wi-Fi. Choose NORVI X3 when a cellular 4G LTE connection is required and verified with the intended carrier. Both provide modular expansion capability, but a modem variant should never be selected without checking network support.

2. Describe the example machine

Imagine a small test fixture with four discrete sensor signals, four low-duty control outputs and two analog measurements. The example illustrates the selection process, not a wiring diagram or a pre-approved configuration.

Function Example hardware Verification
Processing and connectivity X1 or X3 Network, supply and carrier requirements
Four status inputs X-DI4 Sensor voltage/polarity and GPIO resource use
Four control outputs X-Q4 Actual DC load rating and topology
Four analog current inputs X-AI4 Sensor loop power and 4–20 mA scaling

3. Check compatibility before purchase

Shared bus resources are a real planning factor. For example, some NORVI X modules use I²C addresses while other modules use dedicated CPU GPIO. If you replace the digital-input choice with serial interfaces, confirm the new design does not collide with other direct GPIO modules. For larger BOMs, ask for a module-by-module compatibility review.

4. Add supporting parts to the BOM

5. Verify the prototype

First run a bench test using non-safety I/O. Check each input and output with a known signal, confirm display and network messages, then simulate loss of power and communication. Document final wiring and software versions before site installation.

Get help tailoring the list

Use the NORVI USA catalog to review selected U.S. products and actual prices. For a configuration review, contact NORVI USA with your I/O list and communications requirements. We can help identify the questions to resolve before ordering.

Leave a Reply

Your email address will not be published. Required fields are marked *