Ordering a modular controller starts with more than a CPU. You need a repeatable bill of materials (BOM) that matches real signals, power and network access. This guide illustrates how to organize the first NORVI X configuration while leaving space for engineering validation.
1. Pick the CPU based on connectivity
Choose NORVI X1 when the machine will use wired Ethernet or local Wi-Fi. Choose NORVI X3 when a cellular 4G LTE connection is required and verified with the intended carrier. Both provide modular expansion capability, but a modem variant should never be selected without checking network support.
2. Describe the example machine
Imagine a small test fixture with four discrete sensor signals, four low-duty control outputs and two analog measurements. The example illustrates the selection process, not a wiring diagram or a pre-approved configuration.
| Function | Example hardware | Verification |
|---|---|---|
| Processing and connectivity | X1 or X3 | Network, supply and carrier requirements |
| Four status inputs | X-DI4 | Sensor voltage/polarity and GPIO resource use |
| Four control outputs | X-Q4 | Actual DC load rating and topology |
| Four analog current inputs | X-AI4 | Sensor loop power and 4–20 mA scaling |
3. Check compatibility before purchase
Shared bus resources are a real planning factor. For example, some NORVI X modules use I²C addresses while other modules use dedicated CPU GPIO. If you replace the digital-input choice with serial interfaces, confirm the new design does not collide with other direct GPIO modules. For larger BOMs, ask for a module-by-module compatibility review.
4. Add supporting parts to the BOM
- Appropriately rated power supply and protection devices.
- DIN rail, cabinet, grounding and labeled terminal wiring.
- Field sensor cabling and signal-conditioning components where needed.
- Ethernet network or appropriately provisioned LTE service.
- Test points, maintenance documentation and spare parts policy.
5. Verify the prototype
First run a bench test using non-safety I/O. Check each input and output with a known signal, confirm display and network messages, then simulate loss of power and communication. Document final wiring and software versions before site installation.
Get help tailoring the list
Use the NORVI USA catalog to review selected U.S. products and actual prices. For a configuration review, contact NORVI USA with your I/O list and communications requirements. We can help identify the questions to resolve before ordering.